TM 3-4240-286-20&P
2- 12. PROTECTIVE ENTRANCE CONTROL M ODULE - M AINTENANCE INSTRUCTIONS (CONT).
ACTION
LOCATION
ITEM
REMOVAL
Protective Entrance Con-
Using two screwdrivers, gently pry lens (1) from panel
LOW PRESSURE lamp
(2).
trol Module
Remove lamps (3) from lens (1).
INSTALLATION
Insert lamps (3) in lens(1). Insert lens(1) into panel (2)
as shown in detail A. Press lens into panel until it snaps
into place.
REMOVAL
Lift edge of plate (4) with a sharp tool.
Identification plate
Protective Entrance Con-
trol Module
Pull plate completely off the mounting surface.
INSTALLATION
Thoroughly clean mounting surface with dry-cleaning
solvent (item 4, app D). Mounting surface must be free
of all contamination such as oil, grease, dirt, or any
foreign matter.
Activate the back of the plate with dry-cleaning solvent.
Mount the plate and apply pressure to the plate surface.
Spray or brush plate with aliphatic polyurethane coating
(item 2, app D).
2-66