Section X. TURNBUCKLES
b. Inspection and Maintenance.
80. Description and Function
(1) Check bolt threads for undue wear or
The description and function of the turnbuckles is
damage.
given in paragraph 5.
(2) Clean turnbuckle screw and threads
(3) If turnbuckle screw, threads, and/or clamp
81. Maintenance
head are excessively worn or damaged,
Organizational
maintenance
personnel
are
replace.
authorized to replace the turnbuckles.
c. Installation.
a. Removal. (Fig. 4.)
(1) Reassemble, install and tighten. Check
(1) Use wrench, plyers, or similar tool to turn
that the filter seals are in place and the top
the turnbuckle (10) counterclockwise.
and bottom manifold are tight and in place.
(2) Upon loosening, remove turnbuckles.
Section XI. ELBOW CONNECTOR ASSEMBLY
b. Inspection and Maintenance.
82. Description and Function
(1) Inspect assembly for broken, chipped or
The description and function of the elbow connector
worn ring fittings.
assembly is given in paragraph 5.
(2) Replace the elbow connector assembly if
any part exhibits undue wear as to inhibit
83. Maintenance
operation.
Organizational
maintenance
personnel
are
c. Installation
authorized to replace the elbow connector assembly.
(1) Reinstall assembly by placing elbow over
a. Removal. (Fig. 20.)
manifold.
(1) Turn connector assembly (9) on the hose
(2) Reinstall connector assembly (9).
side to disconnect hose.
(3) Check that all connections are tight and in
(2) Lift elbow coupling assembly off top
place.
manifold.
Section XII. REGULATOR DIAL ASSEMBLY
Then remove assembly (7) from top manifold.
84. Description and Function
b. Inspection and Maintenance.
The description and function of the regulator dial
(1) Inspect regulator dial assembly for bent or
assembly is given in paragraph 5.
damaged parts.
(2) Clean all parts in dry cleaning solvent anti
85. Maintenance
replace those parts that are bent,
Organizational
maintenance
personnel
are
excessively worn or broken.
authorized to replace the regulator dial assembly.
c. Installation.
a. Removal. (Fig. 16.)
(1) Reinstall regulator dial assembly as
(1) Remove two screws (1) holding the
indicated.
assembly to the intake manifold.
(2) Set damper handle to position inlet
(2) Remove screw (3) holding damper handle
damper in accordance with paragraph 70.
to assembly and remove wing nut (6).
35