TM 3-4230-209-20&P
2-78
2-14. DISCHARGE HOSE ASSEMBLY (CONT).
REMARKS
ACTION
LOCATION/lTEM
R E A S S E M B L Y (CONT)
Discharge Hose Assembly/
Keeping the hose clamp (3) drawn tight, flip the punch and holder (10) on the
Punch and holder (10)
frame (7) and strike with hammer to mechanically look the buckle (4) to the
strap of the hose clamp (3). While still holding the ratchet tension wrench (9)
tight, rock the strap band clamping tool back and forth. The band will break
flush with edge of the bend Iockbuckle (4).
Tap the broken end of the hose clamp (3) strap with a hammer to eliminate
any sharp edges. Do not hit the nut (6).
Repeat reassembly procedures for other hose clamps (3).
Install gasket (11).
Gasket (11)
