TM 3-4230-209-20&P
2-96
2-21. SKID BASE SUBASSEMBLY (CONT).
REMARKS
ACTION
LOCATION/lTEM
Skid Base Subassembly/
Replace authorized unserviceable parts.
All components
Skid Base Subassembly/
Clip (1) and screw (2) are required only on Bendix*
Insert clip (1) and fasten with screw (2) to carburetor.
Clip (1)
carburetors.
Screw (2)
Items marked ** should be attached to gasoline
Insert screw (3) through the end of governor control (4) and the bottom
Screw (3)**
engine. Remove and reuse them as they are needed.
hole of the lever on throttle linkage assembly (5). Attach nut (6). Insert
Governor control (4)**
Throttle linkage
carburetor choke stud (7) through the upper hole of throttle linkage
assembly (5)
assembly (5), and attach nut (8). Position throttle linkage assembly (5) in
Nut (6)**
place on top of engine.
Carburetor choke stud (7)**
Nut (8)**
Items marked *** are furnished as parts of throttle
Hexagon head cap
Install hexagon head cap screw (9) through internal tooth lock
linkage assembly (5).
screw (9)***
washer (10), retaining strap (11), throttle linkage assembly (5), and into
Lock washer (10)***
the gasoline engine. Install hexagon head cap screw (9) into gasoline
Retaining strap (11)***
engine three or four turns.
NOTE
Make sure throttle assembly knob on the control panel
assembly is pushed in all the way.
Throttle control cable (12)
Install throttle control cable (12) in throttle adapter (13) and tighten
Throttle adapter (13)
setscrew (14) securely. Tighten hexagon head cap screw (9).
Setscrew (14)***