Make sure positive and negative battey cables are disconnected from the battery terminals in order to prevent grounding. Battery and battery
compartment area may be coated with add due to spillage and/or fumes. Wear protective clothing when working in this area. Before eating, smoking,
or touching your face or clothing wash your hands with a solution of baking soda and water, then flush with dean water. If battery add acts into your
eyes, flush them with clean water and obtain medical treatment immediately. Failure to do so may cause blindness.
Pump Unit/Battery Cables
Positive battery cable (57)
Position positive battery cable (57) from the starter solenoid to the battery
Nut (58)
area. Install and tighten nut (58).
Position ground cable (59) from the rear of the gasoline engine to the
Ground cable (59)
Lock washer (60)
battery area. Install and tighten lock washer (60) and machine bolt (61).
Machine bolt (61 )
Loop clamp (62)
Place loop clamp (62) around positive battery cable (57) and ground cable
Thread-cutting tapping
(59). Aline loop damp (62) over the tapped hole and insert and tighten
thread-cutting tapping screw (63) through loop damp (62) and into the
screw (63)
tapped hole.
Insert two hook bolts (64) through the bottom of the frame and position
Pump Unit/Battery
Hook bolts (64)
battery pad (65) so each hook bolt goes through the hole located on each
Battery pad (65)
end of battery pad (65).
2-69
TM 3-4230-209-20&P
