TM 10-4330-236-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Paragraph
Page
Section I.
Lubrication Instructions.......................................................................................
3-1
Section II.
Operator Troubleshooting....................................................................................
3-1
3-1.
Introduction..........................................................................................................
3-1
3-2.
Malfunction Index................................................................................................
3-1
3-3.
Troubleshooting..................................................................................................
3-2
Section III.
Maintenance Procedures.....................................................................................
3-7
Section I. LUBRICATION INSTRUCTIONS
No lubrication is required by the operator for the 200 GPM filter-separator,
Section II. OPERATOR TROUBLESHOOTING
3-1. INTRODUCTION.
a. The troubleshooting table lists the common malfunctions you may encounter during operation of the 200 GPM
filter-separator. You should perform the tests, inspections, and corrective actions in the order listed.
b. This manual cannot cover all the malfunctions that can occur, nor all tests, inspections and corrective actions. If
a malfunction occurs that is not listed or corrected by the corrective actions listed, notify your supervisor.
3-2. MALFUNCTION INDEX.
Malfunction Index
Page
1. Ice crystals in filter
3-2
2. Drain valve handle. does not rotate
3-3
3. Pressure Relief Valve Opens
3-4.
4. Excessive undissolved water in filter-separator effluent fuel samples
3-5
5. Excessive solids in filter-separator effluent fuel samples
3-6
3-1
