TM 10-4330-236-13&P
2-10. PREPARATION FOR MOVEMENT - continued
WARNINGS
ù When raising the filter-separator turn the jack screw crank handles evenly or the filter-separator
could tip over and cause injury or equipment damage.
ù Do not touch could metal with bare hands when operating under arctic conditions. Frostbite can cause
permanent injury.
For step s refer to figure 2-23.
s. If the filter-separator is to be towed, rotate wheel assemblies (1 and 2) to the down position as follows: (1)
Install the two screw jacks (3) on the frame (4) next to the swivel wheels (1). Align holes (5 and 6) and install pin
(7) to secure screw jacks. Chock the rigid wheels (2) at the other end to prevent the filter-separator from rolling.
NOTE
Two individuals are required to raise the filter-separator.
(2)
Turn screw jack crank handles (8) to raise swivel wheel assemblies (1) off the ground.
(3)
Remove the locking pins (9) and rotate swivel wheel assemblies (1) to the down position.
(4)
Align holes (10 and 11) and install locking pins (9) to lock the swivel wheels assemblies (1) in the down
position.
(5) Turn the screw jack crank handle (8) until the tires (12) on swivel wheel assemblies (1) are on the ground.
(6)
Pull out locking pins (4) and remove jack screws (3).
(7)
Repeat steps 1 through 6 for rotating the rigid wheel assembles (2).
(8)
Stow screw jacks (3) under tank on filter-separator.
2-43
