TM 10-4330-234-13&P
CHAPTER 3
OPERATOR'S MAINTENANCE INSTRUCTIONS
Page
OVERVIEW.........................................................................................................
Section I.
Lubrication Instructions ........................................................................................
Section II.
Operator's Troubleshooting ..................................................................................
Section III.
Operator's Maintenance Procedures ....................................................................
OVERVIEW
This chapter contains operator level troubleshooting.
SECTION I. LUBRICATION INSTRUCTIONS
Paragraph
Page
General...........................................................................................................
3-1. General. The filter/separator requires no lubrication.
SECTION II. OPERATOR'S TROUBLESHOOTING
Paragraph
Page
General ...............................................................................................................
Operator Troubleshooting Procedures .................................................................
3-2.
General. This section contains troubleshooting procedures to determine the probable cause of
observed equipment malfunctions. Inspections are provided to isolate the faulty component and corrective
actions are provided to eliminate the malfunction.
3-3.
Operator Troubleshooting Procedures.
Refer to symptom index to locate the troubleshooting
procedure of the observed malfunction.
a. Table 3-1 lists the common malfunctions which you may find during operation or maintenance of the
filter/separator or its components. You should perform the tests/inspections and corrective actions in
the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or inspections and corrective
actions. If a malfunction is not corrected by listed corrective actions, notify your supervisor.
3-1
