TM 10-4330-234-13&P
WARNING
Use a lifting device with a lifting capacity of at least one ton.
Do not allow unit to swing back and forth while hanging in the
air. If you fail to heed this warning, serious injury or death may
occur to personnel or the equipment may be damaged.
4-4. Unloading.
a. When the filter/separator is received in a crated condition, unload it as near as possible to its
operating or storage site.
b. Use a lifting sling attached to a hoist or crane and lift the crate from the carrier.
4-5. Unpacking.
a. Dismantle the crate, removing top, sides, and ends from the skid base.
b. Remove all tie downs and blocking that secure the filter/separator to the skid base.
c.
Use lifting device to lift the unit from the skid base and place it in position.
4-6. Inspection. Make a general visual inspection of the unit to insure that it is complete. Make sure that no
physical damage has been done during shipment.
a. This unit will usually be installed in a pipeline, therefore it's installation will be of a more or less
permanent nature.
b. The filter/separator must be placed at a level site in an upright position.
c.
Drive ground rod (1) into earth at least 8 feet deep, and fasten ground cable to the ground rod.
d. Connect inlet hose from fuel system to inlet connection (2) on the filter/separator. Connect outlet
hose to outlet connection (3).
4-2
