ITEMS TROOP INSTALLED OR AUTHORIZED LIST AND
ORGANIZATIONAL MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS LISTS
Section I. INTRODUCTION
C-1. Scope
Code
Explanation
Repair parts, special tools, and test equipment
P
a. This appendix list repair parts, special tools,
s u p p l i e d from GSA/DSA, or Army supply
t e s t , and support equipment required for the
system and authorized for use at indicated
performance of organizational maintenance of the
maintenance levels.
Liquid Fuel Filter-Separator.
Repair parts, special tools, and test equipment
P2
b. Repair parts listed represent those authorized
which are procured and stocked for insurance
purposes because combat or military essentiality
for use at the organizational level and will be
of the end item dicates that a minimum quantity
r e q u i s i t i o n e d on an "as required" basis until
be available in the supply system.
stockage is justified by demand in accordance with
P9
Assigned to items which are NSA design con-
A R 710-2.
trolled: unique repair parts, special tools, test,
measuring, and diagnostic equipment which are
C-2. General
stocked and supplied by the Army COMSEC
This Repair Parts and Special Tools List is divided
Logistic System and which are not subject to the
provisions of AR 380-41.
into the following sections:
Assigned to items which are NSA design con-
P10
a. Items Troop Installed or Authorized List-
trolled: special tools, t e s t , measuring, a n d
Section II. A list in alphabetical sequence, of items
diagnostic equipment for COMSEC support
which, at the discretion of the unit commander,
which are accountable under the provisions of AR
may accompany the end item, but are not subject to
380-41 and which are stocked and supplied by the
Army COMSEC Logistic System.
be turned in with the end item.
Repair parts, special tools, and test equipment
M
b . R e p a i r P a r t s L i s t - S e c t i o n I I I . A list of
which are not procured or stocked as such in the
repair parts authorized at the organizational level
supply system but are to be manufactured at
for the performance of maintenance. The list also
indicated maintenance levels.
i n c l u d e s parts w h i c h m u s t b e r e m o v e d f o r
Assemblies which are not procured or stocked as
A
such, but are made up of two or more units. Such
replacement of the authorized parts. Parts lists are
component units its carry individual stock numbers
composed o f a s s e m b l y g r o u p s in ascending
and descriptions, are procured and stocked
numerical sequence, with the parts in each group
separately, and can be assembled to form the
listed in figure and item number sequence.
required assembly at indicated maintenance
c. Special Tools List-Section IV. (Not ap-
levels.
X
Parts and assemblies that are not procured or
plicable).
stocked because the failure rate is normally below
d . F e d e r a l S t o c k N u m b e r a n d Reference
that of the applicable end item or component. The
N u m b e r I n d e x - S e c t i o n V . A list in ascending
failure of such part or assembly should result in
numerical sequence, of all Federal stock numbers
retirement of the end item from the supply system.
appearing in the listings followed by a list, in alpha-
Repair parts which are not procured or stocked.
X1
numeric sequence, of all reference numbers ap-
The requirement for such items will be filled by
the next higher assembly or component.
pearing in the listings. Federal stock number and
X2
Repair parts, special tools, and test equipment
reference numbers are cross-referenced to each
which are not stocked and have no foreseen
illustration figure and/or item number.
mortality. The indicated maintenance level
requiring such repair parts will attempt to obtain
C-3. Explanation of Columns
the parts through cannibalization or salvage. The
item may be requisitioned with exception data,
The following provides an explanation of columns
from the end item manager for immediate use.
found in the tabular lists in sections III and V.
Major assemblies that are procured with PEMA
G
a. Source, Maintenance, and Recoverability
funds for initial issue only as exchange assemblies
Codes (STIR):
at DS and GS level. Those assemblies will not be
(1) Source code indicates the source for the
stocked above the DS and GS level or returned to
listed items. Source codes are:
depot supply level.
