TM 10-4330-236-13&P
4-14.
LATCH PIN, LATCH PLATE AND JUMPER CABLE REPLACEMENT - continued.
b.
Jumper Cable. Refer to figure 4-5.
NOTE
The purpose of the jumper cable is to provide an electrical ground (bonding) connection between
the tank and frame on the filter-separator.
(1)
Removal.
(a)
Remove two nuts (1) and one spring lock washer (2), two star lock washers (3) securing jumper
cable (4) to stud (5) on frame (6).
(b)
Remove two nuts (7) and one spring lock washer (8), two star lock washers (9), one bolt (10), and
star washer (11) securing jumper cable (4) to gage bracket (12).
(2)
Installation
WARNING
Improper grounding (bonding) connections between tank and frame can generate a static
discharge (spark). Make sure jumper cable connection provides a metal-to-metal contact
between tank and frame. A static discharge could ignite fuel or cause an explosion of the fuel
vapor and cause personnel injury or death.
(a)
Attach jumper cable assembly (4) to stud (5) on frame (6) with two star lock washers (3),one spring
lock washers (2), and two nuts (1).
(b)
Attach other end of jumper cable assembly (4) to DP gage bracket (12) with screw (10), star lock
washer (11), two star lock washers (9), spring lock washer (8) and two nuts (7).
Figure 4-5. Jumper Cable Replacement
4-10
