TM 10-4330-236-13&P
CHAPTER 5
DIRECT SUPPORT MAINTENANCE PROCEDURES
Paragraph
Page
Direct Support Maintenance Procedures................................ ................................ ................................ ..........
5-1
5-1.
Introduction................................ ................................ ................................ ................................ .............
5-1
5-2.
Shroud Assembly Repair ................................ ................................ ................................ ........................
5-1
5-3.
Frame Assembly - Repair ................................ ................................ ................................ .......................
5-3
5-1.
INTRODUCTION.
This chapter contains instructions for performing Direct Support Maintenance on the 200 GPM filter-separator.
5-2.
SHROUD ASSEMBLY REPAIR.
This task covers: Repair
INITIAL SET-UP:
Tools
References:
Shop Equipment, Welding field maintenance,
TM 9-237
(Appendix B, Section III, Item 6)
General Safety Instructions
Equipment Conditions:
Shroud removed. Refer to para 4-13.
WARNINGS
Latch pin and latch plate removed. Refer to para
• Do not smoke within 100 feet of filter-separator.
4-14.
• Fuel is toxic to skin, eyes, and respiratory tract.
Identification and instructional plates removed.
Refer to para 4-30.
Refer to figure 5-1.
Repair. Straighten and weld shroud assembly (1) as required. Refer to TM 9-237 for welding procedures. If shroud is
damaged beyond repair. replace shroud assembly.
5-1
