TM 10-4330-236-13&P
4-30. IDENTIFICATION AND INSTRUCTION PLATES REPLACEMENT.
This task consists of:
a.
Removal
b.
Installation
INITIAL SET-UP:
Tools
Equipment Conditions
General Mechanics Tool Kit (Appendix B, Section
Filter-separator removed from system, tank drained.
Refer
III, Item 1)
to para 2-6.
Riveter, Blind, Hand(Appendix B. Section II Item
Air vent valve open. Refer to para 2-6.
5)
Drill (Appendix B, Section III. Item 2)
General Safety Instructions
Materials/Parts
WARNINGS
Drive Screws (Appendix C, Section II)
· Do not smoke within 100 feet of filter-separator.
Rivets (Appendix C, Section I)
· Fuel is toxic to skin, eyes, and respiratory tract.
· Wear safety goggles or glasses to protect your eyes from
airborne objects.
Refer to figure 4-21.
WARNING
Drilling may cause metal particles to go airborne and cause injury. Wear safety goggles or glasses
to protect your eyes.
NOTE
The following procedure is typical for all identification and instruction plates. These plates are
mounted in different locations on the filter-separator
a. Removal. Remove identification and instruction plates (1) by drilling out drive screws (2) or rivets (3).
b. Installation. Install identification and instruction plates (1) and fasten with drive screws (2) or rivets (3).
4-41
