TM 5-4330-217-12
C3
Appendix E is added after Appendix D as follows:
APPENDIX E
REPAIR PARTS AND SPECIAL TOOLS LISTS
INTRODUCTION
Section I.
E-1.
Scope
listed items. Source codes are:
Explanation
Code
a. This appendix lists repair parts, special tools,
Repair parts, special tools, and test equipment sup-
P
test, and support equipment required for the per-
plied from GSA/DSA, or Army supply system and
formance of organizational maintenance of the Liq-
authorized for use at indicated maintenance levels.
P2
Repair parts, special tools, and test equipment
uid Fuel Filter-Separator.
which are procured and stocked for insurance pur-
b. Repair parts listed represent those authorized
poses because combat or military essentiality of the
for use at the organizational level and will be requi-
end item dictates that a minimum quantity be
available in the supply system.
sitioned on an "as required" basis until stockage is
P9
Assigned to items which are NSA design con-
justified by demand in accordance with AR 740-2.
trolled: unique repair parts, special tools, test,
measuring, and diagnostic equipment which are
stocked and supplied by the Army COMSEC Logis-
E-2.
General
tic System and which are not subject to the pro-
visions of AR 380-41.
This Repair Parts and Special Tools List is di-
P10
Assigned to items which are NSA design con-
vided into the following sections:
trolled: special tools, test, measuring, and diag-
nostic equipment for COMSEC support which are
a. Items Troop Installed or Authroized List--
accountable under the provisions of AR 380-41 and
Section II. A list in alphabetical sequence, of
which are stocked and supplied by the Army COM-
items which, at the discretion of the unit com-
SEC Logistic System.
M
Repair parts, special tools, and test equipment
mander, may accompany the end item, but are not
which are not procured or stocked as such in the
subject to be turned in with the end item.
supply system but are to be manufactured at indi-
b. Repair Parts List--Section III. A list of re-
cated maintenance levels.
A
Assemblies which are not procured or stocked as
pair parts authorized at the organizational level for
such, but are made up of two or more units. Such
the performance of maintenance. The list also in-
component units carry individual stock numbers
cludes parts which must be removed for replace-
and descriptions, are procured and stocked sepa-
rately, and can be assembled to form the required
ment of the authorized parts. Parts lists are com-
assembly at indicated maintenance levels.
posed of assembly groups in ascending numerical
X
Parts and assemblies that are not procured or
sequence, with the parts in each group listed in fig-
stocked because the failure rate is normally below
that of the applicable end item or component. The
ure and item number sequence.
failure of such part or assembly should result in re-
c. Special Tools List--Section IV. (Not appli-
tirement of the end item from the supply system.
cable).
X1
Repair parts which are not procured or stocked. The
requirement for such items will be filled by the next
d. Federal Stock Number and Reference
higher assembly or component.
Number Index--Section V. A list in ascending nu-
X2
Repair parts, special tools, and test equipment
merical sequence, of all Federal stock numbers ap-
which are not stocked and have no foreseen mor-
tality. The indicated maintenance level requiring
pearing in the listings followed by a list, in al-
such repair parts will attempt to obtain the parts
phanumeric sequence, of all reference numbers
through cannibalization or salvage. The item may
appearing in the listings. Federal stock number and
be requisitioned with exception data, from the end
item manager for immediate use.
reference numbers are cross-referenced to each il-
G
Major assemblies that are procured with PEMA
lustration figure and/or item number.
funds for initial issue only as exchange assemblies
at DS and GS level. Thsoe assemblies will not be
stocked above the DS and GS level or returned to
Explanation of Columns
E-3.
depot supply level.
The following provides an explanation of col-
NOTE
umns found in the tabular lists in Sections III and
Cannibalization or salvage may be used as a source
v.
of supply for any items source coded above except
those coded X1 and aircraft support items as re-
a. Source, Maintenance, and Recoverability
stricted by AR 700-42.
Codes (SMR):
(2) Maintenance code indicates the lowest
(1) Source code indicates the source for the
13
