TM 5-4330-217-12
C3
Page B-1. Appendix B is added after Appendix A as follows:
APPENDIX B
COMPONENTS OF END ITEMS LIST
INTRODUCTION
Section I.
B-1.
Scope
(2) Item number. The number used to iden-
tify item called out in the illustration.
This appendix lists integral components of and
b. National Stock Number (NSN). Indicates
basic issue items (BII) for the filter separator to
the national stock number assigned to the end item
help you inventory items required for safe and effi-
which will be used for requisitioning.
cient operation.
c. Part Number (P/N). Indicates the primary
number used by the manufacturer which controls
B-2.
General
the design and characteristics of the item by means
The components of end item list are divided into
of its engineering drawings, specifications, stan-
the following sections:
dards and inspection requirements to identify an
a. Section II. Integral Components of the
item or range of items.
End Item. These items, when assembled, comprise
d. Description. Indicates the federal item
the filter separator and must accompany it when-
name and, if required, a minimum description to
ever it is transferred or turned in. These illustra-
identify the item.
tions will help you identify these items.
e. Location. The physical location of each item
b. Section III. Basic Issue Items. These are
listed is given in this column. The lists are designed
minimum essential items required to place the fil-
to inventory all items in one area of the major item
ter separator in operation, to operate it and to per-
before moving on to an adjacent area.
form emergency repairs. Although shipped sepa-
f. Usable on Code. "Usable on" codes are in-
rately packed, they must accompany the filter
cluded to help you identify which component items
separator during operation and whenever it is
are used on the different models. Identification of
transferred between accountable officers. The illus-
the codes used in this list are:
trations will assist you with hard-to-identify items.
Code
Used on
This manual is your authority to requisition re-
(Not Applicable)
placement BII based on Table(s) of Organization
and Equipment (TOE)/Modification Table of Or-
g. Quantity Required (Qty Reqd). This col-
ganization and Equipment (MTOE) authorization
umn lists the quantity of each item required for a
of the end item.
complete major item.
h. Quantity. This column is left blank for use
B-3.
Explanation of Columns
during inventory. Under the received column, list
a. Illustration. This column is divided as fol-
the quantity you actually receive on your major
lows :
item. The date columns are for use when you inven-
tory the major item at a later date, such as for ship-
(1) Figure number. Indicates the figure
ment to another site.
number of the illustration on which the item is
shown (if applicable).
8
