Pump Unit/Connector Panel
Thread-cutting tapping
Insert thread-cutting tapping screw (10), through flat washer (11), the
screw (10)
hole in the chain (12), and into the panel (13). Tighten. Repeat the opera-
tion for each of the other two chains. Make sure the chain is long enough
Flat washer (11)
Chain (12)
to allow each dust cap (14) to be removed.
Panel (13)
Dust caps (14)
Pump Unit/Fuel Tank and
Sediment Bowl
Fuel tank must be installed in pump unit before the
Fuel tank (15)
Working from the engine end and to the rear
prime tank assembly can be installed.
Fuel tank strap (16)
of the pump unit assembly, position fuel
tank (15) on the frame with the liquid quantity
Gasket (17)
transmitter toward the control panel. Put fuel
tank straps (16), with gasket (17) attached,
over the top of fuel tank (15) and insert the
threaded end through frame holes.
Flat washers (18)
Install four flat washers (18) and four hexagon
Hexagon self-locking
self-locking nuts (19) to the threaded ends of
nuts (19)
the fuel tank straps (16). Tighten four
hexagon self-locking nuts (19).
TM 3-4230-209-20&P
2-63
