TM 3-4230-204-12&P
2-5.
OPERATING PROCEDURES (CONT).
a. Filling the M11 DECON (Cont).
10
11
Fold wire back and thread end the
Thread end of wire through large loop
wire through center of the spring
in arming pin (12) and the hole in the
pin hole (14) (pivot roll I of handle)
sealing wire (13); PL wire tight.
from the right hand side. Pull wire
tight.
12
13
a. Thread end of wire
Position base of container on
through lead seal hole
ledge of bracket (15). Fasten
again
from
same
strap (16) around container (5)
direction and pull tight.
and tighten.
b. Crimp lead seal down on
the wire to secure the
sealing wire (13), handle
(2), thumb lever (10), and
arming pin (12) using
pliers
if
available.
Break/trim off excess
wire. 11 tools are not
available,
notify
unit
maintenance as soon as
possible.
2-8