TM 10-4330-236-13&P
2-4. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (Refer To Table 2-1).
Table 2-1. Operator Preventive Maintenance Checks and Services for 200 GPM Filter Separator.
NOTE
If the equipment must be kept in continuous operation, do only the procedures that can be done
without disturbing operation. Make complete checks and services when the equipment is shut
down.
Location
Item
Item To Be
Not Fully Capable
No
Interval
Check/Service
Procedures
Mission If:
WARNING
Failure to properly ground the
filter-separator prior to operation could
allow a static discharge (spark) which
could ignite fuel or cause an explosion of
fuel vapor.
1
Before
Fuel Inlet
a. Inspect coupling for cracks or
Cracked or broken coupling.
Coupling
breaks.
b. Inspect for missing or damaged arms,
Gasket missing or damaged.
plug, chain or gasket.
2
Before
Jack Screws
Inspect for loose, damage, or missing
jack screw.
3
Before
Rigid wheel
a. Inspect for bent mounting parts,
assembly binding bearings.
b. Inspect tire for inflation or
damage.
4
Before
Crowbar
Inspect for damaged or missing crowbar.
5
Before
Access Cover
Inspect for loose, damaged, or missing
Hardware loose, damaged.
hardware.
or missing.
6
Before
Pressure Tubing
Inspect for loose or damaged tubing
Tubing loose or
damaged.
7
Before
DP Gage
a. Inspect for needle indication at 0-5.
Gage reading not between
0-5.
b. Inspect for broken lens.
Lens broken.
8
Before
Jumper Cable
Inspect for loose, damaged, or missing
Jumper cable loose,
jumper cable.
damaged, or missing.
2-5
