TM 3-1040-263-34P
SECTION I
INTRODUCTION
1. Scope
Code
Explanation
This manual lists repair parts required for the
M
Repair parts, special tools, and test equipment
performance of direct support and general support
which are not procured or stocked. as such, in
maintenance of the Compressor, Reciprocating, Power-
the supply system but are to be manufactured
Driven, Flamethrower, 3 1/2 CFM, AN-M4D.
at indicated maintenance levels.
A
Assemblies which are not procured or stocked
2. General
as such, but are made up of two or more units.
This Repair Parts and Special Tools List is divided into
Such component units carry individual stock
the following sections:
numbers and descriptions. are procured and
stocked separately, and can be assembled to
parts authorized for the performance of maintenance at
form the required assembly at indicated
the direct support and general support level in figure and
maintenance categories.
item number sequence.
X
Parts and assemblies that are not procured or
b. Special Tools. Test and Support Equipment List
stocked because the failure rate is normal
- Section III Not applicable.
below that of the applicable end item or
c. Federal Stock Number and Reference Number
component.
The failure of such part or
assembly should result in retirement of the
ascending numerical sequence followed by a list of
end item from the supply s) stem.
reference numbers in ascending alpha-numeric
X1
Repair parts which are not procured or stocked.
sequence, cross-referenced to the illustration figure
The requirement for such item will be filled by
number and item number
the next higher assembly or component.
X2
Repair parts. special tools, and test equipment
3. Explanation of Columns
which are not stocked and have no foreseen
The following provides an explanation of columns in the
mortality.
The indicated maintenance
category requiring such repair parts will
attempt to obtain the parts through
(SMR) Column 1.
cannibalization or salvage. The item may be
(1) Source code indicates the selection status
requisitioned, with exception data, from the
and source for the listed item. Source codes used are-
end item manager for immediate use.
Code
Explanation
G
Major assemblies that are procured with PEMA
P
Repair parts, special tools, and test equipment
funds for initial issue only as exchange
supplied from the GSA/DSA, or Army supply
assemblies at direct support and general
system, and authorized for use at indicated
support level. These assemblies will not be
maintenance categories.
stocked above the direct support and general
P2
Repair parts, special tools, and test equipment
support level or returned to depot supply level.
NOTE
purposes because the combat or military
Cannibalization or salvage may be
essentiality of the end item dictates that a
used as a source of supply for any
minimum quantity be available in the supply
items source coded above except
system
those coded X1.
P9
Assigned to items which are NSA design
(2) Maintenance code, indicates the lowest
controlled: unique repair parts, special tools,
category of maintenance authorized to install the listed
test, measuring, and diagnostic equipment,
item. The maintenance level codes are-
which are stocked and supplied by the Army
Code
Explanation
COMSEC Logistic System and which are not
C .....................Crew or operator
subject to the provisions of AR 380-41.
O ....................Organizational maintenance
P10
Assigned to items which are NSA design
F .....................Direct support maintenance
controlled: special tools, test, measuring, and
H .....................General support maintenance
diagnostic equipment for COMSEC support,
D .....................Depot maintenance
which are accountable under the provisions of
(3) Recoverability code, indicates whether
AR 380-41, and which are stocked and
unserviceable items should be returned for recovery or
supplied by the Army COMSEC Logistic
salvage.
Items not coded are expendable.
System.
Recoverability codes are-
2