TM 11-5915-226-23P
SECTION I
INTRODUCTION
XB-
Item is not procured or stocked. If not available
1. Scope
through salvage, requisition.
This manual lists spares and repair parts; special tools;
special test, measurement, and diagnostic equipment
NOTE
(TMDE), and other special support equipment required
for performance of organizational and direct support
Cannibalization or salvage may be
maintenance of the F-1461/VRC. It authorizes the
used as a source of supply for any
requisitioning and issue of spares and repair parts as
items source coded above except
indicated by the source and maintenance codes.
those coded XA and aircraft support
item as restricted by AR
2. General
(2) Maintenance code. Maintenance codes
This Repair Parts and Special Tools List is divided into
are assigned to indicate the levels of maintenance
the following sections:
authorized to USE and REPAIR support items. The
maintenance codes are entered in the third and fourth
and repair parts authorized for use in the performance of
positions of the Uniform SMR Code format as follows:
maintenance. The list also includes parts which must be
removed for replacement of the authorized parts. Parts
(a) The maintenance code entered in the
lists are composed of functional groups in numeric
third position will indicate the lowest maintenance level
sequence, with the parts in each group listed in figure
authorized to remove, replace, and use the support
and item number sequence.
item. The maintenance code entered in the third posi
b. Section III. Special Tools list. Not applicable.
tion will indicate one of the following levels of
c. Section IV. National Stock Number and Part
maintenance:
Number Index. A list, in National item identification
number (NIIN) sequence, of all National stock numbers
Code
Application/Explanation
(NSN) appearing in the listings, followed by a list, in
alphameric sequence, of all part numbers appearing in
O- Support item is removed, replaced, used at the
the listings. National stock numbers and part numbers
organizational level.
are cross-referenced to each illustration figure and item
number appearance.
(b) The maintenance code entered in the
fourth positions indicates whether the item is to be
3. Explanation of Columns
repaired and identifies the lowest maintenance level
with the capability to perform complete repair (i.e., all
a. Illustration. This column is divided as follows:
authorized maintenance functions). This position will
(1) Figure number.
Indicates the figure
contain one of the following maintenance codes:
number of the illustration on which the item is shown.
(2) Item number. The number used to identify
Code
Application/Explanation
item called out in the illustration.
b. Source, Maintenance, and Recoverability (SMR)
Z- Nonreparable. No repair is authorized.
Codes.
(1) Source code. Source codes indicate the
(3) Recoverability code. Recoverability codes
manner of acquiring support items for maintenance,
are assigned to support items to indicate the disposition
repair, or overhaul of end items. Source codes are
action on unserviceable items. The recoverability code
entered in the first and second positions of the Uniform
is entered in the fifth position of the Uniform SMR Code
SMR Code format as follows:
format as follows:
Code
Definition
PA- Item procured and stocked for anticipated or
Recoverability
known usage.
codes
Definition
Code
Definition
Z- Nonreparable item. When unserviceable, condemn
XA-
Item is not procured or stocked because the
and dispose at the level indicated in position 3.
requirements for the item will result in the
replacement of the next higher assembly.
1
