TM 10-4330-234-13&P
4-14. Filter Canister and Element.
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SETUP:
Tools:
Equipment Condition:
Wrench, Spanner (Item 2, Appendix C)
Cover assembly removed (para. 4-12).
Clamp band, removed (para. 4-13).
Materials/Parts:
Gloves (Item 6, Appendix E)
Cloth, Wiping (Item 3, Appendix E)
Dry Cleaning Solvent (Item 4, Appendix E)
Goggles, Safety (Item 5, Appendix E)
a.
WARNING
The toxic effects of some fuel additives are potentially
dangerous to personnel and property. Avoid repeated or
prolonged skin contact. Use rubber fuel resistant gloves when
replacing elements.
NOTE
Typical procedure given. Procedure is the same for each
canister and filter. Change all filters.
(1)
Insert spanner wrench (1) into two holes (2) on top of canister (3).
(2)
Turn spanner wrench (1) 1/4 turn counterclockwise.
(3)
Lift canister (3) out of tank (4).
(4)
Inspect filter element(s) (5) for dirt build-up.
(5)
Discard dirty filter element.
b.
Cleaning. (figure 4-6)
WARNING
Drycleaning solvent PD-680 used to clean parts is potentially
dangerous to personnel and property. Avoid repeated and
prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100-138 (38-60 ).
F
C
Clean canister (3) with cleaning solvent PD-680.
4-11
