2-12. PUMP UNIT (CONT).
Pump Unit/Prime Tank
Working from the rear and above the pump unit, raise prime tank assem-
The fuel tank assembly must be installed before the
Prime tank assembly (31)
prime tank assembly can be installed.
bly (31) up and over the pump unit frame. Lower prime tank assembly (31)
Mounting brackets (32)
into the frame so the two mounting brackets (32) on the left side of the
tank are next to the hose reel area.
Install two hexagon head cap screws (33), two flat washers (34), and two
Hexagon head cap
hexagon head self-locking nuts (35). Do not tighten two hexagon head
self-locking nuts (35) until all connections are made.
Flat washers (34)
Working from the rear and below the prime tank assembly, wrap antiseiz-
Pipe nipple (36)
ing tape around external threads on the prime tank assembly pipe
nipple (36) in a clockwise direction.
Wrap antiseizing tape around external threads on pipe
Ball valve (37)
Screw ball valve (37), pipe elbow (38), and pipe nipple (39) onto prime
tank assembly (31) as a unit. Tighten and position ball valve (37) so it is at
nipple (39) in a clockwise direction.
Pipe elbow (38)
Pipe nipple (39)
approximately 45° angle and the opening is pointing toward the eductor
Install looking sleeve (40) and sleeve extension (41 ) onto extension
Locking Sleeve (40)
rod (42), aline holes and secure with spring pin (43). Slip nut (44) over
Sleeve extension (41)
Extension rod (42)
extension rod (42). Insert end of extension rod (42) through control panel
and tighten nut (44) onto ball valve (37). Install handle (45), washer (46),
Spring pin (43)
and nut (47).
Flat washer (46)